Bay Networks Baystack 150 boot sequence after power on (software version 2.0.0)

The following output has been captured off the serial console port of an Bay Networks Baystack 150 during its boot sequence after power on.

Device is running software version 2.0.0

Serial settings are: 9600 baud, 8 data bits, no parity and 1 stop bit (9600/8-N-1)

Bay Stack 150 NMM POWER-ON SELF DIAGNOSTIC
-------------------------------------------------------

PROM Checksum Test ..... PASSED
.. PROM Checksum = 0X269B
DRAM ( 01024 KByte ) ..... PASSED
LED Display Test ..... PASSED
E2PROM Integration Checksum ..... PASSED
29F040 512 Kbytes Flash Memory Installed ..... PASSED
Network Monitor SRAM Test ..... PASSED
DL-P2517B NIC Test ..... PASSED
Expansion Module Test ..... PASSED













Stack 150 SYSTEM CONFIG AND RUN TIME IMAGE DOWNLOAD
-------------------------------------------------------

-> DUPLICATED IP CHECKING: (Hit CTRL-C to stop system boot/load )
.. IP Address: 0.0.0.0
.. Subnet Mask: 0.0.0.0
ARP Req Send ARP Reply ARP Retry Time (Sec)
------------ ----------- ----------- ------------------
4 0 3 3

-> DOWNLOAD RUN TIME IMAGE FROM FLASH: (Hit CTRL-C to stop system boot/load )
.. Decompress Run Time Image : 99%


























*******************************************************
* Copyright (c) 1997 *
* Bay Networks, Inc. *
* All Rights Reserved *
* BayStack150 Ethernet NMM Version v2.0.0 *
*******************************************************

Press [Ctrl] + Y to begin