Juniper Netscreen SSG5 boot sequence after power on (ScreenOS version 6.3.0r13)

The following output has been captured off the serial console port of an Juniper Netscreen SSG5 during its boot sequence after power on.

Device is running ScreenOS software version 6.3.0r13

Serial settings are: 9600 baud, 8 data bits, no parity and 1 stop bit (9600/8-N-1)

Juniper Networks SSG5 Boot Loader Version 1.3.3 (Checksum: D8BC25A8)
Copyright (c) 1997-2006 Juniper Networks, Inc.

Total physical memory: 256MB
    Test - Pass
    Initialization - Done

Hit any key to run loader
Hit any key to run loader
Hit any key to run loader
Hit any key to run loader

Loading default system image from on-board flash disk...
Done! (size = 13,369,344 bytes)

Ignore image authentication!

Start loading...
.................................................................
.................................................................
.................................................................
.................................................................
.................................................................
.................................................................
.................................................................
.................................................................
.................................................................
.................................................................
.................................................................
.................................................................
.................................................................
.................................................................
.................................................................
.................................................................
.............
Done.



Juniper Networks, Inc
SSG5/SSG20 System Software
Copyright, 1997-2008

Version 6.3.0r13.0
Cksum:f03ef88f
Load Manufacture Information ... Done

Initialize FBTL 0........ Done
Load NVRAM Information ... (6.3.0)Done
Install module init vectors
Changed to l3 mode
Install modules (01274800,020b8000) ...
PPP IP-POOL initiated, 256 pools

Initializing DI 1.1.0-ns

System config (5856 bytes) loaded

Done.
Load System Configuration ...........................................................................................................................................................................................................................modem is not detected
....Admin status for interface serial0/0 has been changed to disable
.Admin status for interface vlan1 has been changed to disable
....................................................................................................................................................................................................Warning: Policy has predefined service HTTPS with different application.
............................................Disabled licensekey auto update
....................................................Done
system init done..
login: System change state to Active(1)